Welcome: Creatall International Co.,LTD
Language: Chinese ∷  English

LED Inverter

  • new universal 32-65 inch LED LCD TV backlight constant current driver board 80-480mA output
  • new universal 32-65 inch LED LCD TV backlight constant current driver board 80-480mA output
  • new universal 32-65 inch LED LCD TV backlight constant current driver board 80-480mA output
  • new universal 32-65 inch LED LCD TV backlight constant current driver board 80-480mA output
new universal 32-65 inch LED LCD TV backlight constant current driver board 80-480mA outputnew universal 32-65 inch LED LCD TV backlight constant current driver board 80-480mA outputnew universal 32-65 inch LED LCD TV backlight constant current driver board 80-480mA outputnew universal 32-65 inch LED LCD TV backlight constant current driver board 80-480mA output

new universal 32-65 inch LED LCD TV backlight constant current driver board 80-480mA output

  • Product description: new universal 32-65 inch LED LCD TV backlight constant current driver board 80-480mA output
  • INQUIRY

CA-266S new universal 32-65 inch LED LCD TV backlight constant current driver board 80-480mA output


Power operating conditions Input: support 10-28V DC input
Output voltage 88V automatically adapt to the following (the minimum limit for the input voltage, no buck)
[Output current] default 80mA, by shorting R22 R21 R18 R15 R24 resistance, can increase the current, each resistance 80mA. Up to 480mA.
Applicable light bar Large size 26 inch -65 inch (maximum voltage 88V)

Input Interface Definition 1: Power supply 2: Power supply 3: ENA switch control 4: Brightness adjustment signal (voltage dimming) 5: Ground wire 6: Ground wire

[Output interface definition]: Positive and negative (++ -) There are four parallel interfaces, the same definition.


Important features:

1: with protection.

2: Output voltage below 88V automatically.

3: change the current is convenient, the motherboard has six 1206 resistance, a resistance of 80mA, up to 6 resistance is fully connected to 480mA.

4: default only connected to a R13 resistor, the output current of 80mA, will not burn light bar. If it is too dark, flashing or flashing off, try to increase the current. Until the normal brightness, light can not be hot.

5: no load will not burn the board (in the case of no load or bad light output voltage will drop to the input voltage, or in the case of load voltage higher than 88V will be reduced to the input voltage value).

6: with 4 output interface, the general definition of ++ -, in the then 2pin left and right of the right light of the interface, directly to the middle of the 2,3 pin can be, 1, 4 pin empty.

If you donot know any repair skill, please consider carefully to buy it


Special attention: when testing, do not connect ADJ feet!

CONTACT US

Contact: Alva Cheng

Phone: 0086 13689587416

Tel: 0755-85270755

Email: sales@creatall.com

Add: Floor 5th,Bldg A, Xin Mao Industrial Zone Xia Wei Industrial 3 Road Long Hua Xin District , Shenzhen City,China